3 in 1 Diamond Microdermabrasion Machine

Two Face Aesthetics is proud to present the revolutionary 3 in 1 Diamond Microdermabrasion Machine! Our machine brings you an unparalleled level of sophistication and convenience with its cutting-edge design. This powerhouse comes complete with a diamond dermabrasion machine, PVC vacuum hose, three diamond pens, nine diamond heads, a heads box & foam, O-rings, cotton filters, power cord, fuses and manual. This impressive package won’t let you down when it comes to tackling skin imperfections such as dirt, blemishes, wrinkles and unwanted pigmentation. Not only that but this system will exfoliate the skin to help it replenish essential natural nutrients for improved cell activity and ultimate health. What’s more is that it can be utilised at the comfort of your home or salon without breaking a sweat! All you have to do is insert one of the cotton swabs into the diamond head and attach it to the hand piece for safe but effective use. For complete ease and convenience all regulated using one vacuum intensity regulator which you can adjust according to your comfort needs. Get ready for flawless skin today with our 3 in 1 Diamond Microdermabrasion Machine - now available at Two Face Aesthetics!

Functions

Abrade or rub off the top skin layer by using sterile diamond heads.
Remove dirt, skin debris, imperfections, blemishes, wrinkles and unwanted pigmentation on the skin.
Helps replenish natural nutrients, restore cell activity and promote skin health.

Operating instruction

Push in the movable ring of copper nozzle at the hand piece, and pull out the 8x5 size vacuum hose. Then push in the black plastic ring on the vacuum hose.
Put a drop of cream or milk lotion on the vacuum hose nozzle, push in the moveable ring and insert in the vacuum hose to the limit.
Insert a cotton swab into the Diamond Head, then tight up the Diamond Head on the hand piece. Remove the cotton swab after every treatment.
Turn on the power switch.
Adjust the Vacuum intensity by Vacuum Regulator according to the reference table, the intensity displays on vacuum gauge and check for comfort.
Use the incline area of Hand piece to contact with the skin surface. Proceed with a slow sliding motion. Do not place the hand piece at one spot for too long, doing this will cause harm to the skin.
Adjust the crystal flow rate by Vacuum Regulator slowly from minimum to maximum. For common use, don\'t set the flow rate to maximum unless it is of necessity. This is better comfort intensity.
Gently stretch the skin with thumb and finger, and glide the Hand-piece 2 to 3 times over the area being treated.
Then cross again in different directions to prevent streaking lines as in the reference picture. Brush strokes or prevent streaking lines as in the reference picture. Brush strokes or polishing motions may be used in different sites.
After treatment, brush off all remaining dead skin with a soft brush and rinse with damp sponges or damp cool towel.
Allow skin to dry then apply desired skin product.
To clean the Diamond Head, use toothbrush or cotton swab damped with a little alcohol to wipe off the dirty impurity, and then use UV light or high temperature for sterilisation.

Aesthetic Consumables

3 in 1 Diamond Microdermabrasion Machine

500mm Graduated Kidney Dish - 1pcs

21G 1.5" (38 mm) Needle (Green) - Unisharp x 100

24k Gold Vibrating Beauty Bar

Aging Fat Pad Poster Laminated

BD 0.3ml Insulin Syringe & Needle 8mm x 30g x 100

Arteries, Veins, Nerves Poster

Arnica Cream - 30g

CPR Face Mask

Clinisept+ Aftercare 100ml

Clinisept+ Skin 490ml

BD Venflon Peripheral IV Catheter Ported 22g, 25mm Winged - Single